Usage

Einfache Bedienung

High-Tech für jeden


	And this how it works:

Select a person type.

Adjust body size.

The next steps needs to be repeated once for each combination of mattress an lying position:

a

In the section “Measurement”, you push the button for the desired mattress and the selected lying position.

b

Wait a short instance while collecting data (usually 20 seconds)

c

Push the button for the next mattress resp. lying position. Or you push the same button again to terminate measuring.

The measuring is terminatedand you can present the pressure images to your customer.

The Buttons "back position" and/or "side position" permit a change-over into the desired view. With the sliding controls at the right and lower border you can rotate the graph around the vertical and the horizontal axle.

You can show to your customers, in which body zones high pressures arises and which body zone is not supported well.

The comparative side-by-side representation makes the differences between two mattresses obvious immediately.